Strong cable clip for IKEA KALLAX, BESTÅ and more

You know how it is: charging cables, power adapters, and extension cords end up hanging around and quickly look messy. This cable clip was designed for exactly that—featuring a very tight fit straight from the printer (“straight from the printer”) and a design tuned to common IKEA furniture thicknesses.

According to the design description, the grip is made to work without any additional tape; in an example test, the clip remained stable even with a load of around 200 g. (Note: this is a real-world example, not a guarantee for every environment or cable combination.)

Fit & Variants (important)

The underlying design is intended for two cable diameters: 5 mm and 11 mm.
There are also versions for different furniture/shelf thicknesses, including:

• KALLAX inner (16.2 mm) & outer (37.2 mm)

• BESTÅ shelves/walls (18.35 mm), top panel (30.7 mm), center divider (37.7 mm)

• and others (e.g., IVAR, LACK, …)

Tip: Quickly measure your edge thickness and cable diameter—this will ensure the best fit.

3D Printing Notes

• 3D print finish: Fine layer lines and minor surface marks are typical of the manufacturing process and do not constitute a defect.

• With frequent re-clipping, heat, or sustained high load, the grip may decrease over time.

Legal Notice (Trademark)

IKEA, KALLAX, and BESTÅ are trademarks of third parties. This product is compatible accessory hardware and is not affiliated with IKEA.